Bul Armory Ms-2 rödpunktsikte 5 MOA

3,975.00kr

Kan restnoteras

Artikelnr: BUL-MS-2 Kategorier: , ,

Beskrivning

Specifications
Window lens Size:
Length: 49.5mm / 1.9”
Width: 27.4mm / 1.07”
Height: 29.4mm / 1.1”
Weight: 30g / 1.0 ounce
Dot size: 5MOA
Dot Intensity: 8 Levels
Working Temperature: -20~+55C
Housing Material: 6061-T6 aluminum alloy
Battery Type: CR2032
Battery Runtime: 20,000 hours (the weakest visible dot)
IPX6 waterproof
Footprint: Trijicon RMR®

WARNING:
NEVER LOOK AT THE SUN THROUGH THE RED DOT SIGHT, IT MAY PERMANENTLY DAMAGE YOUR EYES.
MAKE SURE THE FIREARM IS UNLOADED, CLEAR AND POINTED TO A SAFE DIRECTION WHEN OPERATING OR ZEROING THE MS-2 OPTIC.
MOUNTING:
The MS-2 optic uses a Trijicon® RMR footprint and will mount to any firearm, optic mount or plate system that uses this footprint.
Securely tighten the MS-2 optic with the included screws.
Make sure not to over tighten the screws as it may damage the MS-2 optic’s body or internal parts.
*Do not exceed 16 inch / pounds of torque on the screws.
WINDAGE & ELEVATION ADJUSTMENT:
-The windage dial (left to right) is located on the right side of the MS-2 optic.
-The elevation dial (up and down) is located on the top of the MS-2 optic.
-Use the supplied wrench to adjust your MS-2 optic.
BATTERY EXCHANGE:
The MS-2 optic is powered by a single CR2032 battery. If the dot of the MS-2 optic grows dim or does not turn on,
dismount the MS-2 optic from the firearm and replace the battery.
Do note that after removing the battery you will need to re-adjust the MS-2 optic.
MS-2 OPERATION:
-Press the + button to turn on the MS-2 optic.
-Press the – button for 4 seconds to turn off the MS-2 optic.
-Use the + / – button to adjust the brightness of the sight (8 levels of brightness).
-The MS-2 comes with a built in motion sensor. After 3 minutes of rest, the sight will turn off automatically.
When the sensor senses a vibration or movement, it will turn on immediately.
MAINTENANCE:
-When cleaning the lens, first blow away any dirt and dust, or use a soft lens brush.
Fingerprints and lubricants can be wiped off with lens tissue or a soft clean cotton cloth moistened with lens cleaning fluid.
-All moving parts of the red dot sight are permanently lubricated. Do not try to lubricate them.
-No maintenance is needed on the MS-2 optic outer surface, except to occasionally wipe off dirt or fingerprints with a soft cloth.
-Use the included optic cover when not in use.
STORAGE:
Avoid storing the MS-2 optic in hot places, such as the passenger compartments of vehicles on hot days.
The high temperatures could adversely affect the lubricants and sealants. A vehicle’s trunk, a gun cabinet or a closet is preferable.
Never leave the red dot sight where direct sunlight can enter either the objective lens.
Damage may result from the concentration (burning glass effect) of the sun’s rays.